Argox PT-10 Manual de usuario descargar pdf (Pagina 34)

4.4.4.2 Boot Configure

Mode Setting: This is used to set up the mode to standard Mode or Program Mode

when power on.

Program Mode: When the collector is under Standard Mode, if you want to set

Program Mode, you should have at least one user program stored in collector for user’s

selection. When you complete the setting from Standard Mode to Program Mode, the

system will restart automatically and execute the specified user program.

Standard Mode: When the collector is under Program Mode, if you want to set

Standard Mode, you need to power off the collector and use Hot-key (ESC

+PW

) to power on it. And then you will enter the Setting Menu to change the Power on

Mode to Standard Mode.

For more information about mode changing, please see Power-on Operation in page 24

& 25.

4.4.4.3 Password

For security reason, each time when you want to enter Setting Menu, you need to input

a password to confirm the authority. The password was composed of 4 digits and the

default password is “0000”.

4.4.4.4 F/W Upgrade

Sometimes the F/W might be changed for improving performance or other reasons. In

any case you need to change the collector firmware; you will need to make it through

ArgoLink software. Argox strongly suggest users not to change firmware by your own.

Please contact your PT-10 / PT-12 local supplier for this technical support.

Argox will not be liable for any damage or system crash by improper operations of

firmware change without advice or instruction from Argox or Argox’s authorized

support center.

Please refer to ArgoLink manual for details.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40 41 42

Sin comentarios

Argox PT-10 Manual de usuario Pagina 34