Argox OS-2130D Manual de usuario descargar pdf (Pagina 15)

OS-2130D & OS-2130DE User’s Manual

Troubleshooting by LED and Buzzer Indicators

Diagnosis

Normally, when the printer is in not working properly, the "Power"

LED blinks continuously, and printing and communication

between the host and printer stops. Refer to LED indications

listed below to understand possible solutions to resolve the

problems printer may run into.

LED Indicators: Power and Ready LEDs blink at the same tempo

Power LED Ready LED

ON ON

OFF OFF

Possible Problems

Solutions Remarks

Media sensor cannot

index label gaps

Check the label path

Check the label sensor

If a continuous label roll

is in use, set

“continuous media”

printing in driver

settings or commands.

Media out Install a new label roll

Paper jam Recover the jam

OS-2130D & OS-2130DE User’s Manual

LED Indicators: Only the Power LED blinks

Power LED Ready LED

ON ON

OFF ON

Possible Problems

Solutions Remarks

Serial IO error Check serial baud rate at

both of your system and

the printer.

For serial interface only

Cutter has failed, or

there is paper jam

inside the cutter.

Check the cutter or

recover paper jam.

Only applicable when

cutter mode to cutter

mode.

Other possible

hardware errors.

Contact the reseller for

further service.

LED Indicators: Only the Ready LED blinks

Power LED Ready LED

ON ON

ON OFF

Possible Problems Solutions

Print head needs to

cool down

Printing will stop until the print head cools to

normal printing temperature.

Once it completes, the printer will

automatically resume the printing tasks sent

previously.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 36 37

Comentarios a estos manuales

Sin comentarios

Argox OS-2130D Manual de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Impresoras De Etiquetas Argox OS-2130D