Argox R-400PLUS Especificaciones descargar pdf (Pagina 26)

6.3 LED Indicators

There are three LED indicators on the front panel,

“READY”, “MEDIA” and “RIBBON”. These indicators

display the operation status of the printer.

READY

The READY indicator will remain lighted except if

any of the following conditions prevail.

- Receiving data from host.

- A fault condition.

MEDIA

The MEDIA indicator will remain on for the normal

operation of the printer.

- The printer is at PAUSE state.

- Blinking – Media run out. (READY will be also

blinking.)

RIBBON

ONI– under thermal transfer mode with ribbon

installed.

OFF – under direct thermal mode. (No ribbon

installed.)

Set by Windows driver or command.

Blinking – Ribbon run out. (READY will be also

blinking.)

Notes:

1. We suggest you perform “ media calibration “.

- for the first time media installation

- after change different type or size of media

2. After calibration, the printer will save the related parameters

(reflection characteristics, label length, etc.) to E

PROM.

Without calibration, the incorrect media/Gap detection may

occur, especially for small-size labels (less than 20mm in

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 69 70

Sin comentarios

Argox R-400PLUS Especificaciones Pagina 26