Argox PA-60 Manual de usuario descargar pdf (Pagina 31)

X Draws Box Y Sets Serial Port

Syntax Xp

↵ Syntax Yp

↵

Description This command is used to draw a box by an “OR” operation.

Description This command is used to setup the serial port on the printer for

matching with the host. The protocol between the host and the printer

should be same otherwise unpredictable results will occur.

Parameters p

: X coordinate of start point in dots.

: Y coordinate of start point in dots.

Parameters p

: Baud rate. Acceptable values are: p

: Thickness of four edges.

Value Speed

38 38,400 baud

19 19,200 baud

96 9,600 baud

48 4,800 baud

24 2,400 baud

: X coordinate of end point in dots.

: Y coordinate of end point in dots.

Example N↵

A50,30,0,4,1,1,R,"BOXES"↵

X50,120,5,250,150↵

X120,100,3,180,280↵

: Parity. O - odd parity, E - even parity and N - none parity.

P1↵

: Data bit number, 7 or 8.

Output

: Stop bit number, 1 or 2.

Notes:

1. For some printers p2, p3 and p4 are ignored. The data format for such printers is

always 8 bit data, none parity and 1 stop bit.

2. The factory defaults for RS232 are 9600 baud, 8 data bits, none parity and 1 stop

bit.

3. This command is not used for those model with DIP switches, For X2000+/X3000+,

you can set baud rate via the DIP switches on the rear of the printer.

Example Y19,N,8,1↵

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 40 41

Sin comentarios

Argox PA-60 Manual de usuario Pagina 31