Argox AME-3230B Manual de usuario descargar pdf (Pagina 17)

AME-3230 & AME-3230B User’s Manual

Performing Calibration

If labels with gaps/black marks are in use, perform media calibration

before printing to make printer index correctly.

1. Properly install labels.

2. Power off the printer.

3. Press and hold the FEED button then turn on power; do not

release the button until printer starts to feed labels.

4. Then, press FEED button once or twice to check that labels

are correctly indexed.

Printing a Configuration Report

The Configuration report, also known as the Self-Test report, can

work as a printer diagnosis tool. Steps to print a Configuration report

are listed below:

1. Press the Power Button to turn off the printer.

2. Make sure the Battery is installed and media is loaded.

3. Press and hold the Feed Button, and then press the Power

Switch to turn on the printer.

4. After printer starts to print, release the Feed Button.

5. Wait until printer finishes printing, then press the Power Switch

or Feed Button to resume normal printing mode.

Note: You must always carry out calibration when changing

media. Failure to do so will result in improper

detection by the label sensor.

AME-3230 & AME-3230B User’s Manual

Sample printout of Configuration (Self-Test):

Firmware Version Firmware version

Flash memory capacity

RS-232 parameters

Standby duration (in minutes)

Bluetooth PIN code

Media type setting

Printed label length

1 2 ... 12 13 14 15 16 17 18 19 20 21 22

Sin comentarios

Argox AME-3230B Manual de usuario Pagina 17