Argox OS Series Especificaciones descargar pdf (Pagina 18)

Resetting to Factory Default Settings

1. Turn on the printer and wait for 5 or more seconds.

2. Press the "Feed" button for 10 seconds, and the "Ready"

indicator and "Power" indicator will go off in order.

3. When the two indicators relight, release the feed button.

4. The printer feeds 8 inches of label stock, and then resets

to the factory defaults.

Note: All settings are stored in non-volatile E2PROM and are

retained even after the printer is turned off.

Computer Connections

Note: You must insert the power supply’s barrel connector into

the power jack on the back of the printer before

connecting communication cables.

This printer comes with both a nine-pin Electronics Industries

Association (EIA) RS-232 serial data interface (for OS-203, it is

six-pin) and a standard Centronics parallel interface. In either

case, you must supply the required interface cable for your

application.

Note: This printer complies with FCC Rules and Regulations,

Part 15, for Class B Equipment, for use with fully shielded

six-foot data cables. Use of longer cables or unshielded

cables may increase radiated emissions above Class B

limits.

Serial (RS-232) Interface Requirements

The required cable must have a nine-pin "D" type (for the OS-203,

six-pin) male connector on one end, which is plugged into the

mating serial port located on the back of the printer. The other end

of the signal interface cable connects to a serial port on the host

computer.

For technical and pin-out information, please refer to the

Reference Technical Information, Interface Specification.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 40 41

Sin comentarios

Argox OS Series Especificaciones Pagina 18