Argox OS Series Especificaciones descargar pdf (Pagina 19)

Power Jack

RS232 Serial Port

Parallel Port

Power Jack

Parallel Port

RS232 Serial Port

OS-204 / OS-214 /

OS-214Zip / OS-314 Models

OS-203 Model

Parallel Interface Requirements

The required cable (IEEE 1284-compliant is recommended) must

have a standard 36-pin parallel connector on one end, which is

plugged into the parallel port located on the back of the printer.

The other end of the parallel interface cable connects to the

printer connector at the host computer. For pin-out information,

refer to the Reference Technical Information, Interface

Specification.

Serial and Parallel Cabling Requirements.

Data cables must be of fully shielded construction and fitted with

metal or metalized connector shells. Shielded cables and

connectors are required to prevent radiation and reception of

electrical noise.

To minimize electrical noise pickup in the cable:

• Keep data cables as short as possible (6 ft or 1.83m

recommended).

• Do not tightly bundle the data cables with power cords.

• Do not tie the data cables to power wire conduits.

Notes:

1. Centronics allows a much higher communication speed

than serial.

2. The printer automatically detects parallel or serial port.

No need to set a switch or send a command.

3. Default settings are included in the configuration report.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 40 41

Sin comentarios

Argox OS Series Especificaciones Pagina 19