Argox OS Series Especificaciones descargar pdf (Pagina 29)

Troubleshooting

Normally, when the printer is in not working properly, the "Power"

LED blinks continuously; while printing and communication

between the host and printer stops.

LED Diagnosis

Power and Ready LEDs blinking continuously indicates printer

errors. To understand the problem, please observe the Power

and Ready LEDs and refer to the following solutions:

LED Indicators: Power and Ready LEDs blink at the same tempo

Power LED Ready LED

ON ON

OFF OFF

Possible Problems Solutions Remarks

Miss-detect gap

Check the label path

Check the label sensor

If you use a

continuous label roll

and run under

Windows, select

continuous media.

Label stock out Supply the label roll

Label stock not

installed

Install the label roll

Label jam Recover the jam

LED Indicators: Power and Ready LEDs blink alternately

Power LED Ready LED

ON OFF

OFF ON

Possible Problems Solutions Remarks

Ribbon out Supply the ribbon roll

Ribbon jam Recover the jam

Ribbon sensor error Replace ribbon sensor

Not applicable to

direct thermal

type.

Note: For models OS-203/OS-204 this error will not occur.

LED Indicators: Only the Power LED blinks

Power LED Ready LED

ON ON

OFF ON

Possible Problems Solutions Remarks

Serial IO error Check the baud rate Not for Centronics

Memory full Add the extension RAM

Cutter failed, or jam

at cutter

Check the cutter

Recover the jam

Occurs only when

installing or setting the

cutter

Hardware error Call for service

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 40 41

Comentarios a estos manuales

Sin comentarios

Argox OS Series Especificaciones Pagina 29

Comentarios a estos manuales

Relacionado con productos y manuales para Impresoras De Etiquetas Argox OS Series