Argox F1 Manual de usuario descargar pdf (Pagina 24)

Media Calibration

After the media is loaded, please perform media calibration to

calibrate the label sensor in advance.

1. Turn off the printer

2. Press and hold the PAUSE button and turn on the power.

3. When “CALIBRATION …” is displayed on the LCD, and

both READY and MEDIA indicators blink, release the

PAUSE button.

(The Ethernet models will first prompt “ETHERNET CARD

INITIALIZING” on LCD after Power-on and then show the

“CALIBRATION …” message as described above.)

4. The printer feeds 12-inches of blank labels.

5. When “READY” is displayed, the READY and MEDIA

indicators stop blinking but remain illuminated.

Note: For X-1000VL, the steps about LCD can be ignored.

Important!

1. It’s suggested to perform media calibration after changing

media types.

2. Before calibration, be sure media and ribbon (for thermal

transfer printing) have been loaded correctly. The label sensor

needs to locate properly to index labels’ gaps/ notches/ holes.

3. After media calibration is finished, printer stores settings into its

flash. Without media calibration, printer may detect labels with

less accuracy, especially for small labels less than 1.5” high.

Printing a Configuration Report

To perform a self-test and print a configuration report, helping to

check printer’s print quality and internal settings. Steps as below:

1. Turn off the printer.

2. Load media and ribbon.

3. Press and hold the FEED button while turning on the

power.

4. When “SELF-TEST …” is displayed on the LCD, release

the FEED button.

(The Ethernet models will first prompt “ETHERNET CARD

INITIALIZING” on LCD after Power-on and then show the

“SELF-TEST …” message as described above.)

5. The printer now prints out a configuration report.(as the

sample in next page)

6. Printer will enter Dump mode after printing configuration.

In Dump mode, all characters will be printed in 2 columns:

the right shows characters received from your system, and

the left are the corresponding hexadecimal values of the

characters. It allows users or engineers to verify and

debug the program.

To return to normal operation mode from Dump mode,

press the CANCEL button. Another way is to turn off

printer power, and then restart printer.

Note: For X-1000VL, the steps about LCD can be ignored.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 62 63

Comentarios a estos manuales

Sin comentarios

Argox F1 Manual de usuario Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Impresoras De Etiquetas Argox F1