Argox F1 Manual de usuario descargar pdf (Pagina 41)

Print Head Print Line Position

When the label only exhibits locally inferior printing quality and the

ribbon is not wrinkled, the position of the print head shall be

adjusted, and the adjusting position is shown as Fig. 1. The

viewing direction is facing the machine, and using hex socket

screw driver for the adjustment.

The adjusting portions for two hex socket screw locks marked in

Fig. 1 are shown in Fig. 2 and Fig. 3. When the right side of the

label exhibits inferior printing quality, as shown in Fig. 2, the screw

at the right side shall be adjusted. When the left side of the label

exhibits inferior printing quality, as shown in Fig. 3, the screw at

the left side shall be adjusted. The adjusting steps are as follows:

1. Clockwise rotate the screw a half circle and test printing;

observe whether the printing quality has been gradually

improved or not; and stop the adjustment if the quality is

improved.

2. Repeat Step 1; if the printing quality has not been

gradually improved after five times, counterclockwise

rotate five circles back to the original position and then

proceed Step 3.

3. Counter-clockwise rotate the screw a half circle and test

printing; observe whether the printing quality has been

gradually improved or not; and stop the adjustment if the

quality is improved.

Figure 1

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 62 63

Sin comentarios

Argox F1 Manual de usuario Pagina 41