Argox F1 Manual de usuario descargar pdf (Pagina 55)

1 (CENTER)

Sensor 1 is positioned in the center of the

media route. This option enables sensor 1.

2 (LEFT)

The position of sensor 2 is to the left side of

sensor 1. This option enables sensor 2.

MEDIA CAL LENGTH

Set the maximum label length to calibrate.

12 INCH (1~30)

The default media calibration length is 12

inches.

MEDIA CALIBRATION

Calibrate and detect media gap. Press

<Enter> to activate this operation.

PRINT MODE

Setup label removal method. The method

you select must correspond to the print

mode. Press the up <↑> and down <↓>

buttons to scroll through the selection.

NORMAL

TEAR OFF

This parameter establishes the position of

the labels over the tear-off bar after printing.

PEEL OFF

Enables label peeler mode.

CUT

The printer automatically cuts a label after it

is printed.

BY COMMAND

Sets a specific number of labels for cutting by

command.

CUT AFTER

BATCH

The printer waits to cut after the number of

labels you set in BATCH COUNT.

BATCH COUNT

0001 (1~9999)

Sets the number of labels for BATCH CUT.

BATCH CUT

The printer waits to cut after the number of

labels you set with ―P‖ command to the

printer.

SINGLE CUT

Sets cut after one label

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 79 80

Comentarios a estos manuales

Sin comentarios

Argox F1 Manual de usuario Pagina 55

Comentarios a estos manuales

Relacionado con productos y manuales para Impresoras De Etiquetas Argox F1